Bescor Mp 101 Manual

  понедельник 04 марта
      57

Used for remote control of video cameras, digital cameras or security cameras. Grafik provideniya tehnicheskogo obsluzhivaniya avtomobilej obrazec. This unit is very quiet. It is used in churches, on masts, aerial photography, jib arms, camera cranes, videography, law enforcement, architectural photos, etc. Two motors allow independent and simultaneous smooth adjustment of vertical tilt and horizontal panning. You can pan and tilt at the same time, you can make diagonal movements. Speed is continuously adjustable from 3 to 12 degrees per second.

Pans 180 degrees in 15 to 60 seconds. Supports cameras up to 6 lbs. Not intended for use in direct rain. 15 degree Vertical Tilt up and 15 degree Vertical Tilt down. 30 degree total Vertical Tilt.

170 degree Pan to the right and 170 degree Pan to the left. 340 degree total Horizontal Panning. They operate for years, have a thick plastic case, brass worm gears, no backlash, a light touch remote control. The hand held remote control has a cable 4 foot long. Auto mode sweeps an arc of 45, 90 or 340 degrees. Toronto gothic font free. Uses 4 'AA' cells or 6 to 8 VDC external power supply. Size 4'W x 4.5'H x 5.75'L.

This item: Bescor MP-1B Motorized Pan Head Kit, Includes MP-101 Motorized Pan Head with Remote Control, 90-645 $154.95 In stock. Ships from and sold by Adorama Camera.

Weight of motor only is 30 Oz. The top has a Standard 1/4'- 20 thread for your camera. The bottom has a Standard 1/4'- 20 thread for your tripod or bracket. We supply all the equipment necessary for a complete system. # MP-50ft 50 foot extension cable # MP-PS 120VACb Battery eliminator Manufactures Specifications: Pan movement: ------------------+170 degrees to -170 degrees in horizontal plane (340 degrees total). Tilt movement: --------------------+15 degrees to -15 degrees in vertical plane (30 degrees total).

Pan speed: ------------------------3 degrees per second to 12 degrees per second. (Continuously adjustable) Tilt speed: ------------------------- 1 degrees per second to 3 degrees per second (Continuously adjustable). Two motors: -----------------------allows for diagonal movements, you can pan and tilt at the same time Maximum Load: ------------------6 pounds in upright position.

(center of gravity at 1.5'above plate). Maximum Cable length: ------- 600 feet by extending the control cable.

Hand held remote control: ---- Has a 4 foot long cable. Mounting: ---------------------------Standard 1/4'- 20 thread top & bottom, inverted mounting is okay. Operating temperature: --------38 F to 115 F. Dimensions: -----------------------4' Wide x 4.5' High x 5.75' Long Weight: ------------------------------Weight of motor only is 30 Oz.

Power Source --------------------Uses 4 'AA' cells or 6 to 8 VDC external power supply. Auto mode: ------------------------sweeps an arc of 45, 90 or 340 degrees. Ready to use pan tilt system. All vertical measurements are taken from the center of the image as seen through the camera. The camera may have a wide angle lens and show much more above and below the center lines. The camera may have a telephoto lens and show only a small amount above and below the center lines.

Hand held remote control. Up, Down, Right, Left.

The hand held remote control has a 4 foot long cable. Speed is continuously adjustable using the slide speed control. You can pan and tilt at the same time. You can make diagonal movements. Up and Right, Down and Right Up and Left, Down and Left. Close-up of the bottom part of the hand held remote control.

The left image shows a normal Hand held remote control. The center image shows a custom hand held remote control. This image shows 8 arrows on the round directional control switch.

The eight arrows on this image is just a Photoshop addition of 4 more arrows to show visually that every controller can make the pan tilt head move diagonally. Such as, both up and to the right at the same time.

Eight directions is correct. The 4 normal arrows make some people think it will only go in four directions. This controller can pan continuously with the help of the toggle switch on the bottom. The user does not need to keep their finger on the round directional control switch. The toggle switch on the bottom takes the place of your finger on the round directional control switch. This controller with the toggle switch on the bottom was made in the USA and cost more than the market would accept, about $170.00.

All the other components are made in China and are priced as expected. The right image shows a close up of the speed control. The speed is continuously adjustable using the slider speed control.

Adjustable from 3 to 12 degrees per second. GENERAL INSTRUCTIONS: A. Install the Batteries Open the battery compartment by sliding the cover downward and hinging it outward, insert 4 AA batteries in the same position as the markings inside the battery compartment. For best performance Alkaline type or Ni-Cad rechargeable type batteries are recommended.